
Use one of these Masonry drill bits to create pilot holes into hard earth to help the deployment of your longer GroundGrabba Pro I or Pro II.
What You Get
Your choice of:
- 1x 1/2" x 12"Masonry Drill with HEX shaft / shank
- 1x 1/2" x 24"Masonry Drill with HEX shaft / shank
- 1x 1/2" x 24"Masonry Drill with SDS shaft / shank
Specifications
12" Model
- 1/2” x 12″
- 1/2″ Masonry Drill Bit to pre-drill holes into very hard ground to help make the insertion of GroundGrabba Pro possible.
- Made of hardened steel with a tungsten tip.
- Speed Hex clip in style shank
Weight: 0.129lbs
Dimensions: 1/2 × 12 in
24" Models
Hex Speed Shank
- 1/2” x 24″
- 1/2″ Masonry Drill Bit to pre-drill holes into very hard ground to help make the insertion of your GroundGrabba Pro, Pro I or Pro II possible.
- Made of hardened steel with a tungsten tip.
- Speed Hex Clip in style shank
Weight: 0.26lbs
Dimensions: 1/2 × 24 in
SDS Shank
1/2” x 24″
1/2″ Masonry Drill Bit to pre-drill holes into very hard ground to help make the insertion of GroundGrabba Pro, Pro I or Pro II possible.
Made of hardened steel with a tungsten tip.
SDS shank
Weight: 0.26lbs
Dimensions: 1/2 × 24 in
Additional Information
If you go camping on really hard compact ground and you’re finding it almost impossible to drive your GroundGrabba Pro, Pro I or Pro II into the ground then try pre-drilling the ground using this 1/2″ x 24″ masonry drill bit.
You may need to drill the ground an inch or two at a time and keep clearing the hole if the ground is ‘that’ hard. Perhaps you may also need to widen the hole too.
Video
Disclaimer
⚠ Caution:
❌ Do not use in grounds where there are underground services such as but not limited to: electricity, gas, phone, data, water.
❌ Do not use GroundGrabba products for any other purpose other than ground anchoring.
- Misuse or abuse of GroundGrabba products can lead to injury or worse to the user or bystanders.
- When using motorized drills please refer to the drill manufacturers warnings and safety instructions prior to use with GroundGrabba products.
- Only use GroundGrabba products for their intended purpose.
- Always hold your drill firmly with both hands and use the inside of your legs as a drill guide with the drill handle in between your legs to help prevent torque twisting wrist or other injury.
- Clear the hole you are drilling often during the process.
- Use a good quality high torque drill or hammer drill.
- Some grounds will be impenetrable.
Warranty
Masonry Drills come with a twelve month manufacturer defect replacement warranty
*conditions apply